Galvanized vs Stainless Fence Staples: Which One Should You Buy?
Galvanized and stainless fence staples compared by material, installation, holding power and pack size, with two examples of each side from the listings.

On this page
Top picks at a glance
As an Amazon Associate I earn from qualifying purchases.
- 1
Fas-n-Tite Double Barbed Fence Staples9.6/10View on Amazon - 2
SVLING 3/4 Inch Fence Staples for Wire Fencing9.5/10View on Amazon - 3
Insaga 304 Stainless Fence Staples, 200 Pack9.5/10View on Amazon - 4
Insaga 304 Stainless Fence Staples, 100 Pack9.4/10View on Amazon
Galvanized vs stainless fence staples verdict: Choose galvanized staples for hammer-driven wire fencing on wood posts. Choose stainless staples when the fastener must come out again, with drill install and stated reuse.
Fixing wire to a wood post is a regular run chore, and the staple choice shapes how the fence holds and how easily a fastener moves later. This galvanized vs stainless fence staples comparison covers both sides, with galvanized and stainless examples from the listings.
CoopKeeperHQ earns a commission if you buy through our links, at no added cost to you. Affiliate disclosure.
Four examples

Fas-n-Tite Double Barbed Fence Staples
A 5 lb box of double barbed, hot-dipped galvanized staples, #8 x 1-1/2 inches, for wire fencing on wood posts.
Who it's for: keepers fastening wire fencing to wood posts.
Who should skip it: keepers wanting drill-driven fasteners.
The Fas-n-Tite listing is a 5 lb box of double barbed staples, #8 x 1-1/2 inches, hot-dipped galvanized steel, for wire fencing on wood posts. The listing states two sets of barbs for grip, a hot-dipped galvanized coating for rust and corrosion protection, and ASTM F1667 and ASTM A153 standards. It lists 289 pieces and describes hammer or hammer tacker installation.
Pros
- Two sets of barbs for grip in treated lumber and hardwood posts
- Hot-dipped galvanized coating for rust and corrosion protection
- ASTM F1667 and ASTM A153 standards stated
- Can be driven with a hammer or hammer tacker
Cons
- No warranty term is stated
- Size fixed at #8 x 1-1/2 inches
- Gray color only in this listing
- Hammer or hammer tacker install only

SVLING 3/4 Inch Fence Staples for Wire Fencing
A 400-piece pack of U-shaped, double-pointed, hot-dipped galvanized staples, leg length 3/4 inch, for wire fencing.
Who it's for: keepers hammering wire mesh, woven, welded or barbed wire to wood posts.
Who should skip it: keepers wanting a larger leg length or a drill-driven fastener.
The SVLING listing is a 400-piece pack of U-shaped, double-pointed staples, leg length 3/4 inch, for wire OD 1/4 inch, in hot-dipped galvanized carbon steel. The listing states a hot-dipped galvanizing process for rust and corrosion resistance and a U-shaped design for clamping force. Inside the listing, the title lists a diameter of 0.078 inch while the spec table lists 0.08 inches, and the title figure is trusted here over the spec table.
Pros
- 400 pieces for fencing projects
- Hot-dipped galvanizing for rust and corrosion resistance
- U-shaped, double-pointed design for easy hammering into wood
- Clamping force to hold wire mesh and fencing to wooden posts
Cons
- No warranty term is stated
- Leg length fixed at 3/4 inch
- Hammer install only

Insaga 304 Stainless Fence Staples, 200 Pack
A 200-pack of 304 stainless staples with screws and a hex adapter, drill-installed and reusable.
Who it's for: keepers wanting drill-driven staples that can be removed and repositioned on wire fencing.
Who should skip it: keepers wanting hammer-driven staples.
The Insaga 200-pack is 304 stainless staples: 200 fasteners, 200 screws and 1 hex adapter, installed with a power drill. The listing states anti-rust and anti-corrosion steel, 2 teeth on each side for holding power, and reuse with removal and repositioning. It states no pre-drilling or hammer is required, with a cordless electric drill for installation.
Pros
- 304 stainless steel with anti-rust and anti-corrosion stated
- Drill install, no pre-drilling or hammer
- Reusable, removal and repositioning stated
- 2 teeth on each side for holding power in wood
Cons
- No warranty term is stated
- Drill install only, no hammer option stated
- Spec thread size differs from the 100-pack listing
- Weight listed only as 2.88 kg in the spec table

Insaga 304 Stainless Fence Staples, 100 Pack
A 100-pack of 304 stainless staples with screws and a hex adapter, drill-installed and reusable.
Who it's for: keepers wanting a smaller drill-driven, reusable staple pack for wire fencing.
Who should skip it: keepers wanting a larger pack or hammer-driven staples.
The Insaga 100-pack is 304 stainless staples: 100 fasteners, 100 screws and 1 hex adapter, installed with a power drill. The listing states anti-rust and anti-corrosion steel, 2 teeth on each side for holding power, and reuse with removal and repositioning. It states no pre-drilling or hammer is required, with a cordless electric drill for installation. Its spec table lists a thread size of 0.063 inches and a groove diameter of 0.06 inches, unlike the 200-pack listing.
Pros
- 304 stainless steel with anti-rust and anti-corrosion stated
- Drill install, no pre-drilling or hammer
- Reusable, removal and repositioning stated
- 2 teeth on each side for holding power in wood
Cons
- No warranty term is stated
- Drill install only, no hammer option stated
- Spec thread size differs from the 200-pack listing
- Weight listed only as 1.45 kg in the spec table
Other options for the coop
Cat's Claw Fasteners Screw In Fence Staples for Wire FencingCheck price on Amazon
200 PCS Fence StaplesCheck price on Amazon
200 Pcs Stainless Steel Fence Staples Fence Nails forCheck price on Amazon
200 PCS Fence Staples 304 Stainless Reusable Wire FencingCheck price on Amazon
12 Inch Landscape StaplesCheck price on Amazon
180 Pcs Wire StaplesCheck price on Amazon
Galvanized vs stainless fence staples: side by side
| Factor | Galvanized side | Stainless side | Example from the listings |
|---|---|---|---|
| Material | Hot-dipped galvanized steel | 304 stainless steel | SVLING and Insaga examples |
| Installation | Hammer; hammer tacker on Fas-n-Tite only | Cordless electric drill, no hammer | Fas-n-Tite and Insaga examples |
| Reuse | Not stated as reusable | Reusable, repositioning stated | Insaga examples state reuse |
| Pack size | 400 pieces; 5 lb box with 289 pieces | 200 pack; 100 pack, each with screws and adapter | SVLING, Fas-n-Tite, Insaga examples |
| Wire fit | Wire OD 1/4 inch in the SVLING example | No wire diameter stated in the stainless examples | SVLING example only |
These figures are the coop makers’ own ratings, read from each listing on 28 October 2026.
Material and rust protection
Both sides state rust protection, but by different means. Galvanized examples state a hot-dipped galvanizing process or coating on carbon steel or galvanized steel, for rust and corrosion resistance. Stainless examples state 304 stainless steel with anti-rust and anti-corrosion properties. The Fas-n-Tite example also states ASTM F1667 and ASTM A153 standards. Compare the stated coating or material, since the listings give no shared corrosion figure.
Installation: hammer or drill
Installation is the clearest split. Galvanized examples describe hammer work: SVLING states easy hammering into wood, and Fas-n-Tite states driving with a hammer or hammer tacker. Stainless examples state drill work instead: no pre-drilling or hammer is required, with a cordless drill and a hex adapter in each pack. Without a drill, a keeper can still drive the galvanized examples with a hammer.
Holding power and reuse
Both sides state holding power, with different designs. SVLING states clamping force and hold under tensioned wire or animal impact, while Fas-n-Tite states two sets of barbs for grip in treated lumber and hardwood posts. Stainless examples state 2 teeth on each side that dig into wood, with holding power. Only stainless examples state reuse, with removal and repositioning by power drill.
Pack size and wire fit
Pack sizes differ, so count fasteners before ordering. SVLING lists 400 pieces, Fas-n-Tite lists a 5 lb box with 289 pieces, and Insaga packs list 200 and 100 fasteners, each with matching screws and 1 hex adapter. For size, SVLING lists wire OD 1/4 inch, a leg length of 3/4 inch and a diameter of 0.078 inch in its title, while Fas-n-Tite lists a staple size of #8 x 1-1/2 inches. Stainless examples state no wire diameter, so match the staple to its own listing size. For staples sized for mesh, see the best staples for hardware cloth guide.
Flock fit
Fas-n-Tite Double Barbed Staples
SVLING 3/4 Inch Fence Staples
Insaga 304 Stainless Staples, 200 Pack
Insaga 304 Stainless Staples, 100 Pack
Fitting It to Your Flock
- Match the staple to the post: galvanized for wood posts; stainless for wire and chain link fencing.
- Match the pack: SVLING 400 pieces, Fas-n-Tite 5 lb box, Insaga 200 and 100 packs with screws and adapter.
- Match the install tool to the chore: hammer for the galvanized examples, with a hammer tacker option on the Fas-n-Tite, and cordless electric drill for the stainless examples.
- For a run adjusted later, use stainless examples, which state removal and repositioning.
FAQ for the flock
Should fence staples be galvanized or stainless for a chicken run?
Both sides state rust resistance: galvanized state a hot-dipped coating, stainless state 304 stainless steel. Pick galvanized for hammer fencing, stainless for drill fasteners that state reuse.
Can stainless fence staples be removed and reused?
Yes, for the Insaga examples: the listings state easy install or removal with a power drill, allowing repositioning, with no pre-drilling or hammer required.
What wire sizes do these staples fit?
The SVLING example lists wire OD 1/4 inch, a leg length of 3/4 inch and a diameter of 0.078 inch in its title. The Fas-n-Tite example lists a staple size of #8 x 1-1/2 inches, not a wire size.
Do galvanized staples need a nail gun?
No. The Fas-n-Tite example states staples can be driven with a hammer or hammer tacker, and the SVLING example states a double-pointed design for easy hammering into wood.
How the Coop Score came out
Each example is scored on performance, build, value, safety and warranty, from the listing alone. Only Fas-n-Tite states a standard, ASTM F1667 and ASTM A153, so only it scores on safety here. None of the listings state a warranty term. The weights are on the How We Pick page.
| Product | Keeper Score | Perf. /35 | Build /25 | Value /25 | Safety /10 | Warranty /5 |
|---|---|---|---|---|---|---|
| Fas-n-Tite Double Barbed Staples | 9.6 | 30 | 21 | 20 | 5 | 0 |
| SVLING 3/4 Inch Fence Staples | 9.5 | 30 | 20 | 21 | 0 | 0 |
| Insaga 304 Stainless Staples, 200 Pack | 9.5 | 28 | 21 | 21 | 0 | 0 |
| Insaga 304 Stainless Staples, 100 Pack | 9.4 | 28 | 21 | 20 | 0 | 0 |
Lower point totals read near 9.2 and the strongest near 9.8; because the conversion is proportional, rank by points equals rank by score.
Which should you choose?
Choose galvanized staples if the fence is driven with a hammer on wood posts and the staple does not need to come out again.
Choose stainless staples if the fastener must be removed and repositioned with a cordless drill and adapter.
Wash your hands after handling birds, eggs or equipment, supervise children around the flock, and check local rules on flock size and roosters before you buy. For sick birds, call a poultry veterinarian or your state extension office. See CDC backyard poultry guidance. Read our Safety Disclaimer.
More coop guides
See every chicken runs and fencing guide, plus the best galvanized fence staples guide and plastic vs steel fence posts guide.




