Staples vs Nails for Chicken Wire: Which One Should You Buy?
Hammer-in U-staples and drill-driven stainless fasteners compared for holding chicken wire to wood posts, by pack size, material and stated grip.

On this page
Top picks at a glance
As an Amazon Associate I earn from qualifying purchases.
- 1
220 Pcs Fencing Staples9.7/10View on Amazon - 2
Zevemomo 36 in x 50 ft 1/4 inch PVC Coated Hardware Cloth9.7/10View on Amazon - 3
AAGUT Landscape Staples 12 Inch Galvanized Garden Stake 119.5/10View on Amazon - 4
HongWay 120 Pack Landscape StaplesView on Amazon - 5
1200 Pcs Wire StaplesView on Amazon - 6
550 Pcs Wire StaplesView on Amazon - 7
Cat's Claw Fasteners Screw In Fence Staples for Wire FencingView on Amazon - 8
Lwmyjx Fence Nail FixtureView on Amazon - 9
100 PCS Fence StaplesView on Amazon
A run of chicken wire sags and gaps when the fasteners give way, and staples vs nails for chicken wire comes down to how the wire is held and how often it must come off again. Hammer-in U-staples go in fast and suit light wire on wood posts, while drill-driven stainless fasteners grip with claws or teeth, resist rust and come back out for reuse. The sections below compare the styles and the fasteners in this guide, so the choice matches the run.
Other options for the coop
HongWay 120 Pack Landscape StaplesCheck price on Amazon
1200 Pcs Wire StaplesCheck price on Amazon
550 Pcs Wire StaplesCheck price on Amazon
Cat's Claw Fasteners Screw In Fence Staples for Wire FencingCheck price on Amazon
Lwmyjx Fence Nail FixtureCheck price on Amazon
100 PCS Fence StaplesCheck price on Amazon
CoopKeeperHQ earns a commission if you buy through our links, at no added cost to you. Affiliate disclosure.
Staples vs nails for chicken wire: the short answer
Use hammer-in U-staples when the job is quick, the wire is light and the posts are wood. The OMOTOOL staples in this guide are galvanized Q195 carbon steel, hard and sharp enough to keep straight when hammered in, with wire diameters of 2.3 mm and 2 mm, a length of 23 mm and a width of 13 mm. Use drill-driven fasteners when the wire must stay tight, the run faces weather, or the fasteners must move later. The stainless listings in this guide install with a drill, grip with claws or teeth, and reverse out for reuse.
When staples are the right call
Staples suit a wood post and a run of wire fencing. The OMOTOOL listings pack 280 pcs and 260 pcs of U-shaped staples, and the galvanized surface resists corrosion on outdoor posts. Hammer each staple over the wire and into the post, and check that the wire sits flat against the wood before moving to the next staple. The 2.3 mm wire of the 280 pcs set is thicker than the 2 mm wire of the 260 pcs set, so it suits the heavier end of light wire work. The listings do not state reuse for hammer-in staples, so treat them as permanent once driven.
When screw-driven fasteners win
Drill-driven fasteners suit wire that must stay tight through weather and come off again for repairs. The LIFENCE listing uses 304 stainless steel with an 8-claw serrated structure that the maker claims gives 5X stronger holding power than traditional U-shaped staples, and the GardenNow listing uses 304 stainless steel with 5 irregular teeth on each side. Both listings install with a drill and reverse out for reuse, and the LIFENCE kit adds hex drivers for a battery-powered drill, while the GardenNow set adds a hex adapter. The GardenNow listing states that the included screws cannot tighten onto metal posts, so wood posts are the confirmed match for these fasteners. The LIFENCE listing claims installation runs 35% faster than manual staples, a maker claim to weigh against the hammer-in speed of plain staples.
The fasteners in this guide
The listings below are ranked by stated specs, with the stainless drill-driven fasteners ahead of the galvanized hammer-in staples for grip, weather resistance and reuse. The LIFENCE 100 pcs kit leads on stated grip: 304 stainless steel, an 8-claw serrated structure, hex drivers and a storage can with a handle. The LIFENCE listing needs a careful read too: one bullet lists 2 hex drivers while the kit list counts 1, so confirm what ships in the kit before ordering. The GardenNow 200 pcs set follows with 304 stainless steel, 5 irregular teeth on each side, a hex adapter and 200 fasteners, and it weighs 4.0 pounds as listed. The OMOTOOL 280 pcs set comes next with the thickest staple wire in this guide at 2.3 mm, and the OMOTOOL 260 pcs set closes the list with 2 mm wire. The 260 pcs listing needs a careful read: the title states 260 pcs while the spec table lists NumberOfItems as 1 and a part number ending in 300, so confirm the pack count before ordering.
How to fasten chicken wire so it stays put
Start with the wire pulled taut against the post, then drive the fastener over the wire and into the wood. Space the fasteners along the post so the wire cannot bow out between them, and add fasteners where the wire meets a corner or a gate post. Check the run after wind and rain, and replace fasteners that have worked loose; the drill-driven listings reverse out, so a loose one can be re-driven instead of replaced. For wire that must move, the drill-driven listings reverse out, while hammer-in staples stay in place once driven. Our hardware cloth vs chicken wire comparison covers the wire itself, and the hardware cloth guide covers mesh that needs a firmer grip.
A simple fastening checklist
- Match the fastener to the post: wood posts suit every listing in this guide, and the GardenNow listing also names vinyl, PVC, steel and composite posts
- Pull the wire taut before driving fasteners
- Use stainless fasteners where the run faces rain and damp
- Keep a hex driver with the drill-driven fasteners for removal and reuse
- Check the wire after wind and rain, and replace loose fasteners
- Confirm the pack count on the OMOTOOL 260 pcs listing before ordering
Birds, breed size, run time and climate in; coop floor, run space, roost length and nesting boxes out.
Wash your hands after handling birds, eggs or equipment, supervise children around the flock, and check local rules on flock size and roosters before you buy. For sick birds, call a poultry veterinarian or your state extension office. See CDC backyard poultry guidance. Read our Safety Disclaimer.
FAQ for the flock
Can I use regular nails instead of staples for chicken wire?
A plain nail grips the wire at a point, while a U-staple wraps over the wire and the claw fasteners in this guide grip it from both sides. The LIFENCE listing describes an 8-claw serrated structure that locks wire firmly in place, and the GardenNow listing describes 5 irregular teeth on each side that anchor into wood. For wire that must stay put, a staple or a claw fastener holds better than a plain nail.
Are stainless steel fasteners worth it for a chicken run?
The stainless listings in this guide use 304 stainless steel, which the LIFENCE listing describes as resisting corrosion, rust and weathering, and the GardenNow listing describes as anti-rust and anti-corrosion. The galvanized OMOTOOL listings state a galvanized surface that resists corrosion. Stainless suits runs that face rain and damp, while the galvanized staples suit quick jobs on wood posts.
Can I remove and reuse these fasteners?
The drill-driven listings state reuse: LIFENCE describes its fasteners as 100% reusable by reversing the drill, and GardenNow describes its fasteners as reusable and repositionable with a power drill. The hammer-in OMOTOOL listings do not state reuse, so treat driven staples as permanent. Keep the hex driver with the kit so removal stays quick.
What size staples fit chicken wire?
The OMOTOOL listings in this guide state wire diameters of 2.3 mm and 2 mm, a length of 23 mm and a width of 13 mm. The LIFENCE listing states a size of 0.65 inches in width by 1 inch in length, and the GardenNow listing states dimensions of 1.7 inches by 0.85 inches by 0.1 inches. Match the staple to the wire and the post, and confirm the size on the listing before ordering.
Do these fasteners work on metal posts?
The GardenNow listing gives two different answers: it states that the included screws cannot tighten onto metal posts, and it also says to install welded wire onto vinyl, wood, PVC, steel and composite fence posts. Treat metal-post use as unconfirmed for this set and confirm with the listing before ordering. The other listings describe wood posts: LIFENCE mentions hardwood and softwood posts, and the OMOTOOL listings mention wood and drywall.
More coop guides
- Hardware Cloth vs Chicken Wire: Which Keeps Predators Out?
- Best Hardware Cloth for Chicken Coop Runs and Aprons
- How to Predator Proof a Chicken Coop and Run
- Best Chicken Wire Cutters for Hardware Cloth (2026)
- Chicken Wire Sizes: Mesh Openings, Gauges and Roll Dimensions
- Hardware Cloth vs Welded Wire: Which One Should You Buy?
See the chicken run and fencing picks and the coop supply guides.




